Single-phase Voltage Stabilisers - IREM POWER QUALITY

Single-phase Voltage Stabiliser characteristics IREM

Single-phase Voltage Stabilisers Ministab and Sterostab IREM

ESTABILIZADORES DE TENSÃO

MONOFÁSICA M

MINISTAB M MONOFÁSICA 1-45 KVA
STEROSTAB M MONOFÁSICA 15-350 kVA

GENERAL CHARACTERISTICS

Mains	Single-phase
Nominal input voltage	220V or 230V or 240V (**)
Nominal output voltage	220V or 230V or 240V (**)
Output accuracy	±1% RMS
Frequency	50/60 Hz ±5%
Admitted load variation	0 to 100%
Admitted overload	10 times the nominal power during 10 ms, 5 times during 6 s, 2 times for 1 minute
Harmonic distortion	<0,1%
Efficiency	>98.5%
Cooling	natural air convection (fan-free system)
Colour	black or RAL 7035 (depending on model)
Protection degree	IP21
Installation	indoor
Standard fittings	digital voltmeter, pilot lamps, tropicalised control boards

(**) to be specified on the order. Different voltage values available on request.

OPTIONAL FITTINGS

SHORT CIRCUIT PROTECTION
OVERLOAD PROTECTION
OVER/UNDER VOLTAGE PROTECTION
SOFT START
MANUAL OR AUTOMATIC BY-PASS
DIGITAL NETWORK ANALYSER DISPLAYING THE ELECTRICAL PARAMETERS
ISOLATION TRANSFORMER
ADAPTING TRANSFORMER
SURGE ARRESTERS
IP54 INDOOR OR OUTDOOR VERSION

ESTABILIZADORES DE TENSÃO
M MODELS

VOLTAGE STABILISERS M MODELS IREM POWER QUALITY

ESTABILIZADORES DE TENSÃO
MINISTAB M
MONOFÁSICA 230V 50/60 Hz, PROTECTION DEGREE IP21

SINGLE-PHASE VOLTAGE STABILISERS IREM table ministab

Fittings: GC: range selector terminal block; L: pilot lamp
Optional fittings: V: digital voltmeter (M2..EV models)
Note: models with different power, and/or different input range, and/or different output accuracy can be quoted on demand

IREM voltage stabilisers are designed to deliver the declared power permanently (24/7) under the worst operating conditions, i.e. at full load, at minimum input voltage and max input current and at the declared ambient temperature.

ESTABILIZADORES DE TENSÃO
STEROSTAB M
MONOFÁSICA 230V 50/60 HZ, PROTECTION DEGREE IP21

SINGLE-PHASE VOLTAGE STABILISERS IREM table sterostab

Fittings: V: digital voltmeter; L: pilot lamp
Note: models with different power, and/or different input range, and/or different output accuracy can be quoted on demand.

IREM voltage stabilisers are designed to deliver the declared power permanently (24/7) under the worst operating conditions, i.e. at full load, at minimum input voltage and max input current and at the declared ambient temperature.