IREM HIGH VOLTAGE IGNITERS FOR METAL HALIDE LAMPS

AD SERIES

H.V. IGNITERS FOR METAL HALIDE LAMPS

A complete range of high voltage igniters expressly designed to strike single and double ended metal halide lamps from 200 to 18000W.
These symmetrical igniters have been designed to be supplied from AC mains line and they are characterized by a compact design, high thermal stability, galvanic insulation and a low noise level. The technical characteristics of all models comply with the specification of the different lamps manufacturers.
The igniters are available with different H.V. poles positions and they are equipped with isolated bushings that make them suitable for a wide variety of applications, including compact and portable lighting systems.
These units should be installed close to the lamp, but thermally shielded from it. The high voltage lead must be as short as possible and carefully insulated to prevent corona discharge and reduction in strike energy. They must be grounded for proper interferences suppression.

AD SERIES
H.V. IGNITERS FOR METAL HALIDE LAMPS

HIGH VOLTAGE IGNITERS FOR METAL HALIDE LAMPS - IREM AD SERIES

1) The igniters can be connected as follows: 1Ph+N+PE or 2Ph+PE
2) The power losses have been measured at nominal lamp current value
3) The size “d” is referred to the igniter insulating bushing All igniters are equipped with isolation bushings and tin soldering contacts. They are supplied without H.V. cables.
Different input voltages or frequencies are available on demand.
IREM holds the right to modify the present datasheet without any prior notice

AD SERIES

1) The igniters can be connected as follows: 1Ph+N+PE or 2Ph+PE
2) The power losses have been measured at nominal lamp current value
3) The size “d” is referred to the igniter insulating bushing
All igniters are equipped with isolation bushings and tin soldering contacts. They are supplied without H.V. cables. Different input voltages or frequencies are available on demand.

IREM holds the right to modify the present datasheet without any prior notice

AD SERIES

1) The igniters can be connected as follows: 1Ph+N+PE or 2Ph+PE
2) The power losses have been measured at nominal lamp current value
3) The size “d” is referred to the igniter insulating bushing
All igniters are equipped with isolation bushings and tin soldering contacts. They are supplied without H.V. cables.

Different input voltages or frequencies are available on demand.

IREM holds the right to modify the present datasheet without any prior notice